Name: FM365J Straight Edge Bander
Brand: CNSK
SKU: FM365J

Overview

Nine processing cells: two glue positions, pressing, head-and-tail trimming, fine trimming, scraping, cleaning and polishing.
The separating-agent spray sits between the two glue positions, so hot-melt that overflows the joint does not settle on the panel face.
5,600 mm bed and a 9–60 mm panel range, for long door panels and worktops on one setting.
The pressure beam lifts electrically, so a mixed batch of thicknesses does not need a hand crank between panels.
11 kW total, 380 V, 0.7 MPa air; frame at 1,700 mm.

FM365J CNSK · Dongguan

Feed rate16 – 23 m/min

Panel thickness9 – 60 mm

Panel width≥ 50 mm

Processing stations9

Total power11 kW

Station sequence

Set the job on the screen; the panel then passes nine cells, with the separating-agent spray between the two glue positions.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

Gluing

Hot-melt adhesive is melted and applied to the panel edge before the band is pressed on.

03

Separating agent

A fine spray separates surplus glue from the panel face, so hot-melt does not mark the board after pressing.

04

Gluing

Hot-melt adhesive is melted and applied to the panel edge before the band is pressed on.

05

Pressing

High-precision pressure wheels load the band evenly as it meets the panel, so the joint sits flat and holds.

06

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

07

Fine trimming

The finishing cut takes the overhang back to the panel face; this is the pass that decides how clean the joint reads.

08

Scraping

Upper and lower edges are scraped to remove trim knife marks, and surplus glue between band and panel comes off.

09

Cleaning

Residual hot-melt is diluted and isolated before polishing, so it lifts off instead of being smeared along the edge.

10

Polishing

Cotton polishing wheels clean the finished edge, leaving it smooth and even with the panel face.

Model	FM365J
Feed rate	16 – 23 m/min
Panel width	≥ 50 mm
Panel thickness	9 – 60 mm
Edge band thickness	0.4 – 3 mm
Edge band width	12 – 65 mm
Pressure beam	Electric lift
Processing stations	9
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	11 kW
Machine size (L × W × H)	5600 × 800 × 1700 mm

Values from the FM365J technical data sheet and the 2026 configuration list.

Separating agentA fine spray separates surplus glue from the panel face, so hot-melt does not mark the board after pressing.
Electric beam liftThe pressure beam is set from the screen rather than by hand crank, so a mixed batch of thicknesses needs no reset between panels.
Two glue positionsA second gluing point follows the separating-agent spray, so the adhesive is applied in two steps on the same pass.
5,600 mm bedThe longest straight-line frame in the 3 series short of the JA/JAH machines, for worktops that would otherwise need two passes.