Name: FM365 Straight Edge Bander
Brand: CNSK
SKU: FM365

Overview

Seven stations on one bed: gluing, pressing, head-and-tail trimming, fine trimming, scraping, cleaning and polishing.
4,010 mm from infeed to outfeed, so the panel is finished in one pass instead of moving between machines.
Built for shelves, panels and cabinet parts in a mixed custom batch.
The pressure beam lifts electrically to 65 mm.
A 60 mm worktop and a 9 mm skin run under the same roller, with no hand crank to reset between them.
Frame at 1,750 mm as standard, or 1,350 mm for container loading.
That is the difference between shipping in a 40 ft box and needing a flat rack.

FM365 CNSK · Dongguan

Feed rate16 – 23 m/min

Panel thickness9 – 60 mm

Panel width≥ 50 mm

Processing stations7

Total power10.7 kW

Station sequence

Set the job on the control screen, then the panel passes the seven processing cells in this order.

01

Control screen

Job set-up runs from a numeric panel or an industrial touch screen running Windows, per configuration. Parameters are entered by touch or input box, and the effect of a change shows at once.

02

Gluing

Hot-melt adhesive is heated and melted, then applied to the panel edge before the band is pressed on.

03

Pressing

High-precision pressure wheels load the band evenly the moment it meets the panel, so the joint sits flat and holds.

04

Head-and-tail trimming

The band is cut flush at the leading and trailing ends of the panel — quickly, and without ragged corners.

05

Fine trimming

Top and bottom overhang is trimmed back to the panel face; this is the pass that decides how clean the joint reads.

06

Scraping

The upper and lower edges are scraped to take off trim knife marks, and surplus glue between band and panel is removed.

07

Cleaning

Residual hot-melt is diluted and isolated before polishing, so it lifts off instead of being smeared along the edge.

08

Polishing

Cotton polishing wheels clean the finished edge, leaving it smooth and even with the panel surface.

Technical data

Model	FM365
Feed rate	16 – 23 m/min
Panel width	≥ 50 mm
Panel thickness, straight or bevelled	9 – 60 mm
Edge band thickness	0.4 – 3 mm
Edge band width	12 – 65 mm
Pressure beam	Electric lift, to 65 mm
Processing stations	7
Control screen	Numeric panel or industrial touch screen (Windows), per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	10.7 kW
Machine size (L × W × H)	4010 × 760 × 1750 mm
Shipping height, low-frame build	1350 mm

Values from the FM365 configuration sheet. Voltage and air supply at site to be confirmed before the order is released.

What the machine is built to do

Seven stations, one passGluing, pressing, head-and-tail trimming, fine trimming, scraping, cleaning and polishing all sit on the same bed, in the order the panel meets them.
Straight edge 9 – 60 mmThin skins and 60 mm worktops run on one setting, so a mixed order does not need a second machine or a second shift.
Electric beam lift to 65 mmThe pressure beam is raised and set electrically rather than by hand crank, which is what makes short runs of very different thicknesses practical.
4,010 mm bedA compact frame for a shop where floor space is the constraint, without dropping any of the seven stations.
1,350 mm shipping heightBuilt at 1,750 mm as standard; the low-frame version goes into a 40 ft container instead of costing a flat rack.
Component origin declaredPLC, drives, motors, screen and switches are domestic supply as standard. Imported components can be specified as a customization and are quoted as such.