Name: FM368C 45° Bevel Edge Bander
Brand: CNSK
SKU: FM368C

Overview

Nine processing cells: 45° saw cutting, bevel gluing, band grooving, straight gluing, bevel and straight pressing, bevel fine trimming, end trimming, bevel scraping and polishing.
The 45° saw cuts the square edge and mills the flat face into the bevel in the same pass, so the mitre is formed once.
Band grooving on the inner face lets the band bend and press around the corner without tearing.
12–40 mm panels, ≥ 80 mm width, 14 m/min — the bevel format is a slower, more precise pass than a straight line.
14.5 kW total, 380 V, 0.7 MPa air.

FM368C CNSK · Dongguan

Feed rate14 m/min

Panel thickness12 – 40 mm

Panel width≥ 80 mm

Processing stations9

Total power14.5 kW

Station sequence

Set the job on the screen; the panel then passes nine cells, bevel first and straight edge second.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

45° saw cutting

One-key milling: the square edge is cut to 45° and the flat face milled into the bevel in the same pass.

03

Bevel gluing

A separate bevel gluing unit applies adhesive evenly, so the 45° band bonds without a visible line.

04

Band grooving

Grooves are cut on the inner face of the band so it bends and presses cleanly around the corner.

05

Gluing

Hot-melt adhesive is melted and applied to the panel edge before the band is pressed on.

06

Bevel and straight pressing

Pressure wheels load the bevel and the straight face together, so both bonds are made in one pass.

07

Bevel fine trimming

Special trim knives bring the bevel band flush to the upper and lower faces; the bevel and straight heads are independent.

08

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

09

Bevel scraping

Scraping on the bevel faces removes knife marks and surplus glue on both faces of the 45° band.

10

Polishing

Cotton polishing wheels clean the finished edge, leaving it smooth and even with the panel face.

Technical data

Model	FM368C
Feed rate	14 m/min
Panel width	≥ 80 mm
Panel thickness	12 – 40 mm
Edge band thickness	0.4 – 1.5 mm
Edge band width	22 – 65 mm
Pressure beam	Electric lift
Processing stations	9
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	14.5 kW
Machine size (L × W × H)	5700 × 800 × 1800 mm

Values from the 2026 configuration list; the machine size follows the configuration sheet. Confirm against the technical data sheet before the order is released.

What the machine is built to do

45° cut and milled in one set-upThe square edge is cut to 45° and the flat face milled into the bevel in the same pass — no second machine, no re-fixturing.
Bevel and straight on one bedThe same line finishes the 45° mitre and the square edge; the station list changes, the operating logic does not.
Band groovingGrooves cut on the inner face of the band let it bend and press cleanly around a 45° corner.
Synchronous bevel pressingPressure wheels load the bevel and the straight face together, so both bonds are made in one pass.