Name: FM368H Straight Edge Bander with Grooving
Brand: CNSK
SKU: FM368H

Overview

Nine processing cells: gluing, pressing, head-and-tail trimming, rough trimming, fine trimming, scraping, double grooving, cleaning and polishing.
Double grooving lets a banded panel leave the line with the slots a profile or a connector needs, instead of going to a second machine.
9–60 mm panels, ≥ 50 mm width, 16–23 m/min.
The EVA pot holds the melt at working temperature through the shift.
18.7 kW total, 380 V, 0.7 MPa air; frame at 5,610 mm.

FM368H CNSK · Dongguan

Feed rate16 – 23 m/min

Panel thickness9 – 60 mm

Panel width≥ 50 mm

Processing stations9

Total power18.7 kW

Station sequence

Set the job on the screen; the panel then passes nine cells, with the grooving unit between scraping and cleaning.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

Gluing furnace

EVA glue pot; the melt is held at working temperature through the shift.

03

Pressing

High-precision pressure wheels load the band evenly as it meets the panel, so the joint sits flat and holds.

04

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

05

Rough trimming

The first trim brings the band's upper and lower edges down to the panel faces and leaves the allowance for the finishing head.

06

Fine trimming

The finishing cut takes the overhang back to the panel face; this is the pass that decides how clean the joint reads.

07

Scraping

Upper and lower edges are scraped to remove trim knife marks, and surplus glue between band and panel comes off.

08

Double grooving

Two grooving positions, for panels that need slots on both faces.

09

Cleaning

Residual hot-melt is diluted and isolated before polishing, so it lifts off instead of being smeared along the edge.

10

Polishing

Cotton polishing wheels clean the finished edge, leaving it smooth and even with the panel face.

Model	FM368H
Feed rate	16 – 23 m/min
Panel width	≥ 50 mm
Panel thickness	9 – 60 mm
Edge band thickness	0.4 – 3 mm
Edge band width	12 – 65 mm
Pressure beam	Electric lift
Processing stations	9
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	18.7 kW
Machine size (L × W × H)	5610 × 920 × 1700 mm

Values from the FM368H technical data sheet and the 2026 configuration list.

Electric beam liftThe pressure beam is set from the screen rather than by hand crank, so a mixed batch of thicknesses needs no reset between panels.
Double grooving on the lineTwo grooving positions cut the slots after banding, so the part is not handled twice.
EVA pot, standard hot-meltThe glue furnace covers the general run of panels; a second adhesive is quoted as a configuration change.