Name: FM368J Straight Edge Bander with Pre-Milling
Brand: CNSK
SKU: FM368J

Overview

Eight processing cells: pre-milling, gluing, pressing, head-and-tail trimming, rough trimming, fine trimming, scraping and polishing.
Pre-milling takes the ripple left by the panel saw off the edge, which is what decides whether a thin band shows a line.
6,200 mm bed, 9–60 mm panels, 16–23 m/min.
Rough and fine trimming on separate heads, so the finishing cut is not asked to do the bulk of the work.
16 kW total, 380 V, 0.7 MPa air; frame at 1,750 mm.

FM368J CNSK · Dongguan

Feed rate16 – 23 m/min

Panel thickness9 – 60 mm

Panel width≥ 50 mm

Processing stations8

Total power16 kW

Station sequence

Set the job on the screen; the panel is milled first, then banded and finished through seven cells.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

Pre-milling

Two milling cutters re-finish the saw marks, burrs and out-of-square edges left by the panel saw, so the band seats on a clean face.

03

Gluing

Hot-melt adhesive is melted and applied to the panel edge before the band is pressed on.

04

Pressing

High-precision pressure wheels load the band evenly as it meets the panel, so the joint sits flat and holds.

05

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

06

Rough trimming

The first trim brings the band's upper and lower edges down to the panel faces and leaves the allowance for the finishing head.

07

Fine trimming

The finishing cut takes the overhang back to the panel face; this is the pass that decides how clean the joint reads.

08

Scraping

Upper and lower edges are scraped to remove trim knife marks, and surplus glue between band and panel comes off.

09

Polishing

Cotton polishing wheels clean the finished edge, leaving it smooth and even with the panel face.

Model	FM368J
Feed rate	16 – 23 m/min
Panel width	≥ 50 mm
Panel thickness	9 – 60 mm
Edge band thickness	0.4 – 3 mm
Edge band width	12 – 65 mm
Pressure beam	Electric lift
Processing stations	8
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	16 kW
Machine size (L × W × H)	6200 × 800 × 1750 mm

Values from the FM368J technical data sheet and the 2026 configuration list.

Pre-milling before gluingTwo cutters take the saw marks and the out-of-square edge off the panel first, so the band meets a clean face instead of bridging a ripple.
Electric beam liftThe pressure beam is set from the screen rather than by hand crank, so a mixed batch of thicknesses needs no reset between panels.