Name: FM368JA Two-Pot Straight Edge Bander
Brand: CNSK
SKU: FM368JA

Overview

Eleven processing cells: pre-milling, gluing, pressing, a second glue pot with fast-melt, a second pressing group, head-and-tail trimming, rough and fine trimming, scraping and double polishing.
The two pots are switched with one key when the band or the board changes, so the line does not stop to empty and re-heat a single pot.
Pre-milling at the head of the line, 9–60 mm panels, 16–23 m/min.
7,500 mm bed, for long parts and for the extra stations.
20 kW total, 380 V, 0.7 MPa air.

FM368JA CNSK · Dongguan

Feed rate16 – 23 m/min

Panel thickness9 – 60 mm

Panel width≥ 50 mm

Processing stations11

Total power20 kW

Station sequence

Two glue groups: the first pot ahead of the first pressing group, the second pot with its fast-melt tank ahead of the second.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

Pre-milling

Two milling cutters re-finish the saw marks, burrs and out-of-square edges left by the panel saw, so the band seats on a clean face.

03

Gluing

Hot-melt adhesive is melted and applied to the panel edge before the band is pressed on.

04

Pressing, first group

The first pressure group seats the band applied at the first glue station.

05

Gluing furnace

EVA glue pot; the melt is held at working temperature through the shift.

06

Fast-melt glue

The fast-melt unit brings the adhesive to working temperature in less time, so a cold start does not hold up the line.

07

Pressing, second group

A second pressure group follows the second glue station, for the band applied there.

08

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

09

Rough trimming

The first trim brings the band's upper and lower edges down to the panel faces and leaves the allowance for the finishing head.

10

Fine trimming

The finishing cut takes the overhang back to the panel face; this is the pass that decides how clean the joint reads.

11

Scraping

Upper and lower edges are scraped to remove trim knife marks, and surplus glue between band and panel comes off.

12

Double polishing

Two sets of cotton wheels finish the edge, for a higher sheen on the joint than a single head gives.

Technical data

Model	FM368JA
Feed rate	16 – 23 m/min
Panel width	≥ 50 mm
Panel thickness	9 – 60 mm
Edge band thickness	0.4 – 3 mm
Edge band width	12 – 65 mm
Pressure beam	Electric lift
Processing stations	11
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	20 kW
Machine size (L × W × H)	7500 × 800 × 1750 mm

Values from the FM368JA technical data sheet and the 2026 configuration list.

What the machine is built to do

Pre-milling before gluingTwo cutters take the saw marks and the out-of-square edge off the panel first, so the band meets a clean face instead of bridging a ripple.
Fast-melt tankThe melt reaches working temperature in less time, so the first panel of a shift is not scrap.
Two polishing headsA second set of cotton wheels finishes the edge after the first pass, for a higher sheen on the joint.
Electric beam liftThe pressure beam is set from the screen rather than by hand crank, so a mixed batch of thicknesses needs no reset between panels.