Name: FM368JC 45° Bevel Edge Bander with Pre-Milling
Brand: CNSK
SKU: FM368JC

Overview

Nine processing cells: 45° saw cutting, pre-milling, band grooving, gluing for both formats, synchronous bevel pressing, bevel fine trimming, end trimming, bevel scraping and polishing.
One gluing and one pressing unit serve the bevel and the straight edge, switched with the format.
15–55 mm panels, ≥ 80 mm width, 14 m/min.
6,400 mm bed, long enough for the pre-milling head and the bevel stations together.
19 kW total, 380 V, 0.7 MPa air.

FM368JC CNSK · Dongguan

Feed rate14 m/min

Panel thickness15 – 55 mm

Panel width≥ 80 mm

Processing stations9

Total power19 kW

Station sequence

Set the job on the screen; the panel is cut and milled, then banded through eight cells.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

45° saw cutting

One-key milling: the square edge is cut to 45° and the flat face milled into the bevel in the same pass.

03

Pre-milling

Two milling cutters re-finish the saw marks, burrs and out-of-square edges left by the panel saw, so the band seats on a clean face.

04

Band grooving

Grooves are cut on the inner face of the band so it bends and presses cleanly around the corner.

05

Bevel and straight gluing

One gluing unit serves both formats — the bevel band and the flat edge — switched with the format.

06

Bevel and straight pressing

Pressure wheels load the bevel and the straight face together, so both bonds are made in one pass.

07

Bevel fine trimming

Special trim knives bring the bevel band flush to the upper and lower faces; the bevel and straight heads are independent.

08

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

09

Bevel scraping

Scraping on the bevel faces removes knife marks and surplus glue on both faces of the 45° band.

10

Polishing

Cotton polishing wheels clean the finished edge, leaving it smooth and even with the panel face.

Model	FM368JC
Feed rate	14 m/min
Panel width	≥ 80 mm
Panel thickness	15 – 55 mm
Edge band thickness	0.4 – 1.5 mm
Edge band width	22 – 70 mm
Pressure beam	Electric lift
Processing stations	9
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	19 kW
Machine size (L × W × H)	6400 × 800 × 1750 mm

Values from the 2026 configuration list. The technical data sheet lists a 15–40 mm bevel range for this model; confirm before the order is released.

45° cut and milled in one set-upThe square edge is cut to 45° and the flat face milled into the bevel in the same pass — no second machine, no re-fixturing.
Pre-milling before gluingTwo cutters take the saw marks and the out-of-square edge off the panel first, so the band meets a clean face instead of bridging a ripple.
Band groovingGrooves cut on the inner face of the band let it bend and press cleanly around a 45° corner.
Synchronous bevel pressingPressure wheels load the bevel and the straight face together, so both bonds are made in one pass.