Name: FM368JH Straight Edge Bander with Notching
Brand: CNSK
SKU: FM368JH

Overview

Ten processing cells: separating agent, pre-milling, gluing, pressing, head-and-tail trimming, rough and fine trimming, scraping, double polishing and notching.
The separating agent keeps surplus glue off the panel face, which matters on the 12–40 mm range where the band is thin.
Double polishing finishes the edge after the first pass, for a higher sheen on the joint.
12–40 mm panels, ≥ 50 mm width, 16–23 m/min; 7,000 mm bed.
18 kW total, 380 V, 0.7 MPa air.

FM368JH CNSK · Dongguan

Feed rate16 – 23 m/min

Panel thickness12 – 40 mm

Panel width≥ 50 mm

Processing stations10

Total power18 kW

Station sequence

Set the job on the screen; the panel is sprayed and milled before the glue, and notched after the second polishing head.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

Separating agent

A fine spray separates surplus glue from the panel face, so hot-melt does not mark the board after pressing.

03

Pre-milling

Two milling cutters re-finish the saw marks, burrs and out-of-square edges left by the panel saw, so the band seats on a clean face.

04

Gluing

Hot-melt adhesive is melted and applied to the panel edge before the band is pressed on.

05

Pressing

High-precision pressure wheels load the band evenly as it meets the panel, so the joint sits flat and holds.

06

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

07

Rough trimming

The first trim brings the band's upper and lower edges down to the panel faces and leaves the allowance for the finishing head.

08

Fine trimming

The finishing cut takes the overhang back to the panel face; this is the pass that decides how clean the joint reads.

09

Scraping

Upper and lower edges are scraped to remove trim knife marks, and surplus glue between band and panel comes off.

10

Double polishing

Two sets of cotton wheels finish the edge, for a higher sheen on the joint than a single head gives.

11

Notching

A slotting unit cuts the notches the profile needs after banding, so a notched panel does not need a second machine.

Model	FM368JH
Feed rate	16 – 23 m/min
Panel width	≥ 50 mm
Panel thickness	12 – 40 mm
Edge band thickness	0.4 – 1.5 mm
Edge band width	22 – 65 mm
Pressure beam	Electric lift
Processing stations	10
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	18 kW
Machine size (L × W × H)	7000 × 800 × 1750 mm

Values from the FM368JH technical data sheet and the 2026 configuration list.

Separating agentA fine spray separates surplus glue from the panel face, so hot-melt does not mark the board after pressing.
Pre-milling before gluingTwo cutters take the saw marks and the out-of-square edge off the panel first, so the band meets a clean face instead of bridging a ripple.
Two polishing headsA second set of cotton wheels finishes the edge after the first pass, for a higher sheen on the joint.
Notching on the lineThe slotting unit cuts the notches a profile panel needs after banding, so the part does not come off the line for a second operation.