Name: FM368Z Narrow-Panel Straight Edge Bander
Brand: CNSK
SKU: FM368Z

Overview

Eight processing cells: gluing, pressing, head-and-tail trimming, rough trimming, fine trimming, scraping, cleaning and polishing.
Panel width from 30 mm — narrow strips and edge build-ups that a standard fence would push off line.
9–60 mm thickness, 16–23 m/min, on a 4,700 mm bed.
Built for shelves, frames and small parts in a mixed custom batch.
11 kW total, 380 V, 0.7 MPa air.

FM368Z CNSK · Dongguan

Feed rate16 – 23 m/min

Panel thickness9 – 60 mm

Panel width≥ 30 mm

Processing stations8

Total power11 kW

Station sequence

Set the job on the screen; the panel then passes eight cells from gluing to polishing.

01

Control screen

Job set-up runs from the screen — parameters entered by touch or input box — and a change shows its effect at once.

02

Gluing

Hot-melt adhesive is melted and applied to the panel edge before the band is pressed on.

03

Pressing

High-precision pressure wheels load the band evenly as it meets the panel, so the joint sits flat and holds.

04

Head-and-tail trimming

The band is cut flush at the leading and trailing ends — quickly, and without ragged corners.

05

Rough trimming

The first trim brings the band's upper and lower edges down to the panel faces and leaves the allowance for the finishing head.

06

Fine trimming

The finishing cut takes the overhang back to the panel face; this is the pass that decides how clean the joint reads.

07

Scraping

Upper and lower edges are scraped to remove trim knife marks, and surplus glue between band and panel comes off.

08

Cleaning

Residual hot-melt is diluted and isolated before polishing, so it lifts off instead of being smeared along the edge.

09

Polishing

Cotton polishing wheels clean the finished edge, leaving it smooth and even with the panel face.

Model	FM368Z
Feed rate	16 – 23 m/min
Panel width	≥ 30 mm
Panel thickness	9 – 60 mm
Edge band thickness	0.4 – 3 mm
Edge band width	12 – 65 mm
Pressure beam	Electric lift
Processing stations	8
Control screen	Numeric panel or industrial touch screen, per configuration
Input voltage	380 V
Air pressure	0.7 MPa
Total power	11 kW
Machine size (L × W × H)	4700 × 800 × 1750 mm

Values from the FM368Z technical data sheet and the 2026 configuration list. The 30 mm panel width is the configuration sheet figure.

Electric beam liftThe pressure beam is set from the screen rather than by hand crank, so a mixed batch of thicknesses needs no reset between panels.
Narrow panels to 30 mmThe fence and the pressure are set for strips, so a narrow part is banded on the line instead of being hand-finished.
Same eight cells as FM368Gluing through polishing on one setting, on the shortest bed in the series.